Design Services
Layouts, 3D renderings, and architect-ready drawings from a custom builder who already knows what the framing crew is going to say. Make your changes on paper, where they're cheap.
Every deliverable is built to be handed off, not redone.
Walk the new kitchen, addition, or reworked floor plan before a single board gets cut. Move a wall, widen an opening, try the island the other way — and see it, not imagine it.
Start hereDimensioned plans and elevations that already account for spans, load paths, and where the mechanicals have to run. Your architect or engineer stamps and refines instead of starting from a blank sheet on your dime.
Ask about scopeClean, measured plans with openings, clearances, and fixture locations so your designer can get straight to finishes and furniture.
Ask about scopeWe source the samples and install the textures on site. You choose off a real wall in your own light, not a screen.
Ask about samplesThe same decision — "let's move that wall" — costs a little on a drawing, a lot at framing, and a fortune after drywall and finishes are in. Design with a builder catches it at the cheap end. What you don't spend on rework goes into the materials and upgrades you'll actually see.
Instead of a full architectural firm's fee to get to a buildable plan, SFCS gets you there for a fraction — then hands the drawings to a licensed professional for the stamp.
Relative cost of one change, illustrated. Every job is different, but the order never is.
Most design problems don't show up in the software. They show up when the crew is standing in the room with the plans. Forty years of being that crew is what's in these drawings.
"I've spent forty-plus years framing, finishing, and fixing what didn't work in real life. I understand structural components, loads, and code requirements from the inside. I'm not a licensed architect or a structural engineer, and I won't pretend to be. What I give you is a buildable design — one the licensed professional who stamps it isn't sending back three revisions deep."
We meet at the house, measure, and talk about how you actually live in the space. This is where the good ideas come from.
You get options you can see and react to. We revise until the plan is the one you'd build.
Architect-ready and designer-ready sets, dimensioned and detailed, packaged for handoff.
Real materials, installed on your wall, so the last decisions are made with your eyes, not a catalog.
Call or text to set up a design walk-through. Serving Huntsville and North Alabama within 50 miles.
256-755-4944Straight Flush Construction Services LLC is a licensed general contractor. Design services are provided as a builder; SFCS is not a licensed architectural or engineering firm. Where a project requires sealed drawings, SFCS prepares the design for review and stamping by a licensed architect or engineer of your choosing.